![]() Service-policy type inspect pmap-Internet-to-Trusted Zone-pair security Internet-to-Trusted source INTERNET destination TRUSTED Service-policy type inspect pmap-Trusted-to-Internet Zone-pair security Trusted-to-Internet source TRUSTED destination INTERNET Policy-map type inspect pmap-Internet-to-TrustedĬlass type inspect cmap-Internet-to-Trusted Policy-map type inspect pmap-Trusted-to-InternetĬlass type inspect cmap-Trusted-to-Internet Policy-map type inspect pmap-Guest-to-Internet Policy-map type inspect pmap-Internet-to-Guest Policy-map type inspect pmap-Trusted-to-TrustedĬlass type inspect cmap-Trusted-to-Trusted Match access-group name Guest-to-Internet Match access-group name Internet-to-GuestĬlass-map type inspect match-all Guest-to-Internet Match access-group name Internet-to-TrustedĬlass-map type inspect match-all Internet-to-Guest Match access-group name Trusted-to-InternetĬlass-map type inspect match-all cmap-Internet-to-Trusted Match access-group name Trusted-to-TrustedĬlass-map type inspect match-all cmap-Trusted-to-Internet Username REDACTED privilege 15 secret 5 $REDACTEDĬlass-map type inspect match-all cmap-Trusted-to-Trusted License udi pid CISCO2911/K9 sn FCZ1616210S Subject-name cn=IOS-Self-Signed-Certificate-2713986641Ĭrypto pki certificate chain TP-self-signed-2713986641 I'm going home and I just can't leave it in a non working state - even in a lab.įigure out where I screwed this up and win a valuable prize. I set it back to the working config for now. Went straight from laptop to g1 on the router - I assumed that even without squawking the vlan id, I should still get an ip - the only things I see in Shark from the router is broadcast junk like eigrp. Vlan id's on the switch definitely match. ![]() I'm thinking I hosed something up in ACL's, or omitted something. ![]() I was ok up to the point of trying to split Giga0/1 into two sub interfaces.Īfter doing that, dhcp no longer functions.Įverything was working, including a Mitel phone and an AP in lightweight mode that gets it's config via the tunnel, right up until the time I moved the 130.1 ip from giga0/1 to giga 01.130 I am struggling to get a 2911 configured as a branch router. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |